Try and practice the latest Fortinet : NSE8_811 real questions & answers

Fortinet NSE8_811 Exam Overview:

Fortinet NSE8_811 Exam Syllabus Topics:

Fortinet NSE 8 Written Exam (NSE8_811) Sample Questions:

1. Click the Exhibit button.
Your customer is using dynamic routing to exchange the default route between two FortiGates using OSPFv2. The output of the get router info ospf neighbor command shows that the neighbor is up, but the default route does not appear in the routing neighbor shown below:

According to the exhibit, what is causing the problem?

A) OSPF requires the redistribution of connected networks.
B) A prefix for the detail route is missing
C) There is an OSPF interface network-type mismatch.
D) FG2 is within the wrong OSPF area.

2. You are building a FortiGala cluster which is stretched over two locations. The HA connections for the cluster are terminated on the data centers. Once the FortiGates have booted, they do form a cluster. The network operators inform you that CRC eoors are present on the switches where the FortiGAtes are connected.
What would you do to solve this problem?

A) Replace the caables where the CRC errors occur.
B) Place the HA interfaces in dedicated VLANs.
C) Change the ethertype for the HA packets.
D) Set the speedduplex setting to 1 Gbps /Full Duplex.

3. Click the Exhibit button.

Referring to the exhibit, a FortiADC is load balancing IPv4 traffic between two next-hop routers. The FortiADC does not know the IP addresses of the servers. Also, the FortiADC is doing Layer 7 content inspection and modification.
In this scenario, which application delivery control is configured in the FortiADC?

A) Layer 7
B) Layer 3
C) Laye.4
D) Layer 2

4. You are asked to implement a single FortiGate 5000 chassis using Session-aware Load Balance Cluster (SLBC) with Active - Passive FortinControllers. Both FortiControllers have the configuration shown below, with the rest of the configuration set to the default values:
config system ha
set mode dual
set password fortinetnse8
set group-id 5
set chassis-id 1
set minimize-chassis-failover enable
set hbdev "b1"
end
Both FortiControllers show Master status. What is the problem in this scenario?

A) The chassis ID settings on FotiControllers on slot 2 should be set to 2.
B) The management interface of both FotiControllers was connected on the some network.
C) The b1 interface the two FortiConrollers do not see each other.
D) The priority should be set higher for ForControllers on slot-1.

5. An organization has one central site and three remote sites. A FortiSIEM has been installed on the central site and now all devices across the remote sites must be centrally monitored by the FortiSIEM at the central site.
Which action will reduce the WAN usage by the monitoring system?

A) Install both Supervisor and Collector on each remote site.
B) Install local Collectors on each remote site.
C) Enable SD-WAN FEC (Forward Error Correction) on the FortiGate at the remote site.
D) Disable real-time log upload on the remote sites.

Solutions: